A customer has asked for the proper port configuration to allow for LAG on a Cisco 2504 Wireless Controller to a Cisco IOS switch. Which Ether Channel mode should be used on the switch to allow for the WLC to connect?
C. desirable D. passive E. active
A customer has asked for its wireless equipment to be managed as securely as possible. Which three management protocols will provide encrypted access to the equipment? (Choose three.) A. Secure Shell
C. SNMPv3 D. Telnet
E. SNMPv2c F. HTTP
Answers A, B, C
When deploying a Cisco Cloud Wireless Infrastructure, what two destination ports must be open? (Choose two.)
C. TCP/5247 D. UDP/5247 E. TCP/7351 F. UDP/7351 G. TCP/7734 H. UDP/7734
Answers F, G
A help desk engineer is attempting to perform a remote packet capture on the wireless network. Which access point mode is necessary to perform this function?
D. rogue detector E. Flex Connect
Refer to the exhibit. A help desk ticket has been entered for the wireless infrastructure. A wireless client is not able to connect at IEEE 802.11n rates. Which option allows for connectivity?
A. Set WMM mode to Optional or Required.
B. Set Quality of Service (QoS) to Silver.
C. Set Quality of Service (QoS) to Platinum. D. Set 7920 AP CAC to Enable.
An engineer has been asked to upgrade the FUS on the Wireless LAN controller. How can they monitor the status of the upgrade?
A. WLC GUI
B. WLC CLI
C. WLC Console
D. WLC Management in Prime Infrastructure
During a wireless site survey, the signal strength drops significantly when outside of the room containing the access point. The building is made of wood and drywall. This is an example of which wireless anomaly?
B. refraction C. fading
D. multipath E. refection
A wireless engineer has been asked to plan a deployment covering the aisles of a warehouse with optimal coverage while bleeding RF across aisles. Which antenna type provides the necessary coverage?
B. omnidirectional C. Yagi
D. parabolic dish
Refer to the exhibit. The wireless engineer has deployed the Cisco 5508 Wireless Controller. The controller is responding on the service port; however, it will not respond on the management interface. Which configuration revision will fix the management interface?
A. On the switch interface, configure switch(config-if)#switchport trunk allowed plan add 10. B. On the WLC management interface, disable LAG on the management network.
C. On the switch interface, configure switch (config-if)#switchport trunk allowed vlan 10. D. On the WLC management interface, change the VLAN ID to 20.
E. On the switch interface, configure no spanning-tree portfast trunk.
F. On WLC Controller > General, disable LAG and reboot.
A help desk ticket states that a wireless access point has not joined its controller and is flashing rapidly. How can the help desk administer the access point with the default settings?
C. Telnet D. HTTP E. HTTPS
Would you like to see more? Donât miss our 200-355 PDF file at: